The London open is the one hour when EURUSD scalping works best: the Asian session ends, London desks start trading, volume jumps, and spreads tighten to their narrowest. This guide turns that hour into one testable setup — mark the 06:00–07:00 UTC quiet-hour range, trade the breakout only after a retest, and size the position from risk. Verdict up front: only trade it when the all-in cost is under 20% of the target.

In this guide: cost math, the setup, the rules, a worked example, and when not to trade.

The EURUSD scalping strategy London open traders use is the quiet-hour breakout: mark the 06:00–07:00 UTC range, wait for an M5 candle to close outside it after 07:00 UTC, enter after price retests the broken edge, stop just inside the range, and target 1.5 times the stop — skipping the trade when spread costs top 20% of the target.

Key takeaways

  • Trade one window only: the London open, 07:00–09:00 UTC, after marking the 06:00–07:00 UTC quiet-hour range.
  • Never chase the first breakout candle. A trade exists only after a retest of the broken range edge holds.
  • On a 7.5-pip target, a 1.0-pip all-in cost eats 13% of the target; a 2.0-pip cost eats 27% and the setup is not worth taking.
  • Risk 0.25–0.50% of equity per trade, with a hard daily loss limit of 2–3% and a pause after three consecutive losses.

What the London open scalp is — and what it is not

The London open scalp is a session breakout trade. Between 06:00 and 07:00 UTC, EURUSD usually drifts in a narrow range, leaving a high and a low on the chart. When London opens at 07:00 UTC, fresh flow often breaks one edge. The trade is that first directional move — not every move of the day.

It is a scalp: the hold lasts minutes, the target is 1 to 1.5 times the range height (typically 6 to 10 pips), and the stop sits just back inside the range — KCM Trade puts the typical major-pair target at 5 to 15 pips. Nothing here predicts where EURUSD closes the day.

What it is not: not a news trade, not a crossover system (EMAs set direction only), not an all-day method (after 09:00 UTC the edge is gone), and not a promise — no setup here guarantees a profit. This article gives no win rate, because none was measured for this rule set. The honest number is the break-even win rate from the cost math, next.

The cost math first

A scalper's enemy is not being wrong about direction — it is paying so much per trade that being right still loses money. The Trading Bulletin's guide notes EUR/USD raw spreads of 0.0–0.2 pips during London and New York sessions, and a $7.00 round-turn commission per lot equals about 0.7 pips. A realistic all-in cost is therefore ~0.9 pips on a good raw account, and 1.0–1.5 pips on a standard account.

All-in costShare of a 7.5-pip targetVerdict
0.2 pips (raw, no commission)3%Excellent
0.9 pips (0.2 spread + 0.7 commission)12%Good — the standard case below
1.0 pips (standard account)13%Acceptable — cleanest retests only
1.5 pips (wide retail spread)20%Borderline — skip unless target is 10+ pips
2.0 pips or more27%Do not trade

The filter, stated by WizardTrader and used here as a hard rule: if spread plus commission is more than 20% of your target, the edge is gone. Slippage counts too — the 20% covers spread + commission + average slippage together.

Costs also move the break-even win rate — the share of trades you must win to end flat. Formula: break-even win rate = risk ÷ (risk + reward), after costs. Before costs, this setup risks 5 pips to make 7.5 pips (1:1.5), so break-even is 5 ÷ (5 + 7.5) = 40%. After the 0.9-pip cost, a win nets 6.6 pips and a loss costs 5.9 pips, so break-even is 5.9 ÷ (5.9 + 6.6) = 47.2%. KCM Trade shows the same effect: a 6-pip risk, 9-pip reward plan breaks even at 40% before costs and 50% after a 1.5-pip cost.

PlanBreak-even win rate
Before costs (5 risk / 7.5 reward)40.0%
After 0.9-pip cost (5.9 / 6.6)47.2%
After 2.0-pip cost (7.0 / 5.5)56.0%

The setup: timeframe hierarchy, indicators, and the quiet hour

EURUSD only: the BIS Triennial Survey, as cited by KCM Trade, puts it at 21.2% of global FX turnover in April 2025, keeping its London spread the tightest available to retail scalpers. Window: 06:00–09:00 UTC.

JobChartWhat you read
DirectionM15Trend; 20 EMA slope; nearest support and resistance
StructureM5Quiet-hour range edges; breakout close; retest
EntryM1Confirmation candle at the retest; exact stop and target

Indicators stay minimal. On M15, a 20-period EMA sets the bias: above a rising 20 EMA means longs only; below a falling 20 EMA, shorts only; a flat 20 EMA means no bias and no trade. On M5, no indicator is needed — the range edges are the indicator. On M1, the 20 EMA is optional confirmation; the trigger is price action. A 14-period ATR on M5 is the one extra worth having: a range narrower than half the ATR puts stops inside noise; wider than twice the ATR, the stop is too large.

Marking the range is mechanical: the highest high and lowest low printed 06:00–07:00 UTC on M5. Height sets the plan — stop just inside the range, target 1 to 1.5 times the height. Under 4 pips or over 12 pips, skip the morning.

WindowUTCWhat to do
Quiet hour06:00–07:00Mark the M5 range; check the spread; do not trade
London open07:00–09:00Trade the breakout-and-retest setup only; max 2 trades
London–New York overlap13:00–17:00Separate window — do not carry the morning range into it
Midday lull, after 17:0009:00–13:00, after 17:00No trades from this setup; the range is stale

Entry, stop, and target rules

If any rule is not met, there is no trade.

  1. Bias (M15). Longs only above a rising 20 EMA; shorts only below a falling 20 EMA. Flat EMA means no trade for the whole window.
  2. Range (M5). The 06:00–07:00 UTC high and low are drawn; height is 4 to 12 pips. Outside that band, the morning is over before it starts.
  3. Spread. EURUSD spread at 07:00 UTC is 1.5 pips or less all-in. If wider, wait five minutes and check again; still wider, no trades today.
  4. Breakout close (M5). A full M5 candle closes outside the range in the bias direction. A wick poking through is not a breakout; a close against the M15 bias is not a trade.
  5. Retest (M5/M1). Price returns to the broken edge and holds it (old resistance becomes support for a long, reverse for a short). One M1 candle must touch the edge and close back in the breakout direction.
  6. Entry (M1). Enter on the close of the M1 confirmation candle. No entry more than two M1 candles after confirmation.
  7. Stop. Just inside the range, 1 to 2 pips beyond the retest low for a long (above the retest high for a short). A stop wider than 8 pips invalidates the trade.
  8. Target. 1.5 times the stop distance, or the far side of the range plus half its height, whichever is closer. Never move the target further once open.
  9. Two trades maximum. After two trades, win or lose, the session is over.
  10. Invalidation. The setup dies for the day if price closes back inside the range on M5, a high-impact release lands in the window, or the daily loss limit is hit.

No competitor combines all ten rules: WizardTrader has no range definition or worked example, the Trading Bulletin never defines a London open trade, and KCM Trade covers the breakout in one table row with no retest, trade-maximum, or invalidation rule.

Worked example (example numbers, not live prices)

Assumptions, all stated: EURUSD, London open, account $5,000, risk 0.5% per trade ($25), raw-spread account with 0.2-pip spread and $7.00 round-turn commission per lot (0.7 pips, per the Trading Bulletin). Prices illustrate KCM Trade's 1.08500-style example — not current prices, not a prediction.

M15 20 EMA rising, price above it: bias long only. The 06:00–07:00 UTC range is high 1.08520, low 1.08460 — 6 pips. At 07:12 UTC an M5 candle closes above 1.08520; price pulls back, touches 1.08520, and an M1 candle closes back up at 1.08530. Entry.

ItemWorkingResult
Entry (buy)M1 confirmation close at the retest1.08530
Stop lossBelow the retest low, just inside the range1.08480, 5 pips
Take profit1.5 × 5-pip stop1.08605, 7.5 pips
Position size$25 ÷ (5 pips × $10 per lot)0.50 lot
Loss if stopped5 × $5.00 pip value at 0.50 lot−$25.00
Gain if target hits7.5 × $5.00+$37.50
Net gain after costs$37.50 − $3.50 − spreadAbout +6.6 pips net

The plan risks 5 pips to make 7.5 pips (1:1.5): 40% break-even before costs, 47.2% after the 0.9-pip cost. The stop sits where the setup is wrong — back inside the range. If the retest had failed, rule 10 kills the setup for the day. One setup, one morning, one result to log.

When NOT to trade

  • High-impact news in the window. Stand aside from 2 minutes before to 5 minutes after CPI, NFP, FOMC decisions, and ECB press conferences — spreads can jump from 0.2 to 3–5 pips around NFP. Check the calendar before 06:00 UTC; a red-folder event between 07:00 and 09:00 UTC makes it a no-trade day.
  • Spread above the filter. Above 1.5 pips at 07:00 UTC and still above it five minutes later: do not trade. The cause does not matter, the number does.
  • No retest. If price breaks out and runs 10 pips without coming back, the trade is gone — chasing it means the worst price and a stop behind no structure.
  • After the limits. After two trades, the daily loss limit, or three consecutive losses, the window is closed — even for a perfect setup at 08:45 UTC.

Risk management

  • Risk per trade: 0.25–0.50% of equity. On $5,000 that is $12.50 to $25.00; beginners start at 0.25% until 50 demo trades are logged. Formula: lots = risk dollars ÷ (stop pips × pip value per lot). For EURUSD the pip value is $10 per lot, so $25 ÷ (5 × $10) = 0.50 lot. Never size from confidence or the last result.
  • Daily loss limit: 2–3% of equity, hard stop. On $5,000 that is $100 to $150. When hit, close the platform — the limit is set before the session, not negotiated during it.
  • Three-loss pause. Three consecutive losses means a 30-minute break minimum. The most common scalping failure is the revenge trade.
  • Journal every trade. Log the range height, spread at entry, entry, stop, target, and result — then judge the rules after 50+ trades against the 47.2% break-even rate. Ten trades proves nothing.

Common mistakes

  1. Chasing the breakout candle. Entering the moment price crosses the edge, without a retest, buys the top of the first push with no structure behind the stop. Fix: rule 5.
  2. Ignoring the spread at entry. A setup that works at 0.2 pips fails at 2.0 pips, and the chart looks identical. Fix: rule 3 — read the spread column before every entry.
  3. Widening the stop mid-trade. Moving the stop deeper turns a planned 5-pip loss into an open-ended one. Fix: accept the planned $25 loss.
  4. Trading breakouts against the M15 bias. A downside break when M15 is rising is a counter-trend scalp with no edge here. Fix: rule 1.
  5. Sizing from the last result. Doubling size after a win or a loss makes risk a function of mood. Fix: the formula, risk fixed until the 50-trade review.

FAQ

What is the best time to scalp EURUSD? The London open, 07:00–09:00 UTC, after the 06:00–07:00 UTC quiet hour — and the London–New York overlap, 13:00–17:00 UTC, as a separate window. KCM Trade agrees, and the BIS figures it cites (UK 38% of global FX turnover, US 19%) explain why.

How many pips do EURUSD scalpers target at the London open? In this setup, 1 to 1.5 times the quiet-hour range height — typically 6 to 10 pips, with a 4- to 8-pip stop. Under 5 pips the cost filter fails; over 12 pips it is no longer the same trade.

Can a beginner use the London open strategy? Yes, on demo first, at 0.25% risk per trade. The rules are simple — one range, one bias check, one retest — but execution is fast and the cost math is unforgiving. Do 50 demo trades with a journal, compare the win rate with the 47.2% break-even rate, then decide.

Is the London open scalping strategy profitable? No strategy can promise that. Whether it makes money depends on execution, costs, and behaviour over a large sample — unknowable from one morning. The test: 50 logged demo trades judged against the break-even rate after costs. Below break-even, change the setup, the filter, or the execution.

Sources consulted

Educational material only — not financial advice. Forex and gold trading with leverage can produce substantial losses. Backtest and demo-trade any setup before risking real capital.